NEW KIT! Project 955 Borei Class SSBN. Yuri Dolgoruki.

Coming in November 2017. After a year of development Zero Bubble model design is proud to offer a 1/140th Scale GRP kit of the Russian Federation Navy Project 955 'Borei' Class SSBN "Yuri Dolgoruki"

 

This kit has been researched and developed over a year and is currently in the final stages of tooling. The kit features two fibreglass hull halves, top and bottom along with two fin pieces and a top sail /fin piece. All appendages are supplied including a 5 piece pumpjet propulsor assembly along with Hydroplanes fore and aft and mast heads. These are all polyurethane castings.

Like all Zero bubble kits it is primarily designed for Radio control.   The kit is 1300 mm long and had a diameter of 95mm.

 

About the Original.

 

The Project 955 Borei class SSBN has been a long anticipated design, intended to replace the ageing Project 667 BDRM Delta III and IV as well as the massive project 941 Bars/Akula Typhoon class SSBN. The development of this design being protracted, a direct consequence of the fall of the Soviet Union and the emergence of the Russian Federation. Design development started in the 1980’s under the direction of the RUBIN Design bureau. The collapse of the Soviet Union initially meant that construction would be delayed and not even certain.

 

In 1996 the first hull, Yuri Dolgoruky was laid down at the Sevmash, Severodvinsk shipyard, but due to ongoing budgetary cuts construction was suspended. She was finally completed and launched in February 2008. Ongoing issues with its RM-56 Bulava missiles that were themselves

undergoing intensive development also meant that the ship was not armed with her complement of missile until later. She was finally commissioned into the Russian Navy in 2010. She is the first of 10 projected Ballistic missile submarines to be operated by the Russian Federation. Since the commissioning of the first Borei class submarine three others have joined the fleet, Alexander Nevsky, Vladimir Monomakh and Kynaz Vladimir.

 

Project 955 Borei SSBN  kit $220  AUD +P&P

About the kit.

The kit comes with basic components including the following:

Hull halves (top and bottom)

2 Sail sides and top piece.

Fore planes, 2 pieces

Stern planes, 4 pieces

Rudders Upper and lower 4 pieces.

Pumpjet propulsor forward shroud

Shroud forward support.

Aftershroud

Propulsor 9 blade.

After shroud Stator.

3 mast heads.

 Illustrated instruction booklet.

 

Kit does not include mast shafts, Propeller shaft , mountings,

water tight cylinder or electronics. Paints, glues or stand.